Advanced protection for every surface of the vehicle

PPF is a transparent or coloured polyurethane film applied over suitable vehicle surfaces. It creates a sacrificial layer that helps protect the finish from stone chips, light scratches, insects, road contamination and everyday wear.

PPF helps absorb minor impacts and surface abrasion, but it cannot make a vehicle damage-proof. Severe impacts, dents, accidents, deep cuts and damage that passes through the film may still affect the underlying surface.

PPF is a thicker protection film designed to absorb impacts and abrasion. Vinyl wrap is primarily used to change colour or appearance. Ceramic coating adds slickness, gloss and easier cleaning, but it does not replace the physical impact protection of PPF.

Clear gloss BODYFENCE films are designed to preserve the original appearance. Matte and satin products intentionally alter gloss level, while BFBLACK, BFBLACKM and CANDYFENCE provide coloured styling together with protection.

No. Coverage can target high-impact areas such as the bumper, bonnet, wings, mirrors and sills, or extend to the full vehicle. The right choice depends on use, exposure, finish expectations and budget.

On applicable BODYFENCE films, fine surface swirls and minor scratches in the top layer can reduce or disappear with ambient heat, sunlight or warm water. Deep cuts and damage through the film do not self-heal.

Allow the film to settle before its first wash and follow the current HEXIS care guide. Use gentle products and soft tools; avoid solvents and abrasives. With a pressure washer, use moderate pressure, remain at least 50 cm away and avoid directing the jet into film edges.

Yes. BODYFENCE uses an adhesive designed to facilitate professional removal with controlled heat and technique. Paint condition, previous repairs and substrate compatibility should be assessed before installation or removal.

BODYFENCE is produced by HEXIS, a French manufacturer of self-adhesive films founded in 1989. Multisign is the distributor and local commercial and technical contact for Romania and Hungary.

Selection depends on surface, finish, panel size and exposure. The range includes gloss BODYFENCEX and BODY XFAST, matte BODYFENCEXM, satin BODYFENCEXS, wide-format BFWIDE, reinforced DFENCEXTRM, coloured films, interior films, and dedicated headlight and windshield solutions.

No. Thickness, adhesive, liner, finish, roll format and intended surface vary by reference. Use the technical data sheet for the exact product rather than applying one specification across the range.

Do not assume identical tack, stretch, slip, edge behaviour or finishing technique. Start with the current BODYFENCE application guide, test the material, use the specified preparation and application method, and consider manufacturer training before commercial work.

The standard BODYFENCE application guide describes wet application, while certain products or situations may use a different process. Follow the current product-specific technical sheet and application guide; do not transfer a method from another reference without checking.

Both approaches are possible. Bulk film supports custom fitting, while BODYKIT and HEXIS PRECUT LAB patterns can improve repeatability, reduce on-vehicle cutting and support more efficient professional workflows.

A compatible treatment can enhance hydrophobic behaviour and maintenance. HEXIS offers NANO SERUM for compatible BODYFENCE and HEXIS films; it is a technical treatment intended for careful professional application. Always verify compatibility before using third-party products.

Warranty duration and eligibility depend on the exact film, installer status and compliance with current requirements. Professional installation, original paint, proof of purchase, vehicle and batch information, and correct maintenance may be required. Check the current official warranty rather than relying on a general duration.